Ads-tec BPC1000 Manual de usuario descargar pdf (Pagina 15)

Industrial PCs BPC1000

4.3 OPERATIONAL READINESS CHECK

• Connect the power cable to the power source.

• Check the device to determine whether damages have been caused by improper

transport, incorrect operation or storage conditions or improper handling (e.g.

smoke emission from the device, etc.). If damages are found, immediately shut

down the device and protect it against unintentional startup.

4.4 PLC SWITCH

The PLC switch is located underneath the cover at the front of the device.

The PLC software can be controlled by using the PLC switch. The function of individual

switch positions may vary depending on the software and PLC version used. Additionally,

you can read current status information by using the keys.

EXAMPLE:

SWITCH POSITION DESCRIPTION

RUN / PROG: Run or programming status

STOP:

PLC is stopped

MRESET:

The PLC is reset

4.5 STATUS DISPLAYS

SYS LED (BICOLOURED)

Depending on the colour and type of flashing different device states are displayed by the

SYS LED.

The following signals are displayed:

• LED lights green The device is ready for operation (Power ON).

• LED flashes red Environmental temperature too high.

• LED is off The device is switched off. (POWER OFF)

4.6 PLC LED (TWO COLORS)

This LED indicates the status of a soft PLC. A soft PLC has to be installed in order for this

LED to display various signals. Various device statuses are indicated by the colors and

flashing patterns of the PLC LED.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

Ads-tec BPC1000 Manual de usuario Pagina 15